Properties and Uses:1,organic silicon of one-component,as neutral,one-component of RTV-silicon rubber.such product is more resistant to oily than other ordinary from silicone pad.mainoyfor the electronic pump seals etc.

2,The product has good acidproof alkali resistance, ageing resistance, ultraviolet ray, excluding the solvent, no pollution, no corrosion, use convenient wait for a characteristic, excellent electrical properties.

3,For metals, ceramics, glass and rubber materials with good adhesive performance, high temperature resistance, excellent performance in - 60 ° c ~ 200 degrees Celsius temperature range can still maintain excellent properties.

4,Is the electronic industry, household appliances, automobile industry, high-pressure substation equipment etc. Good adhesive, sealing, insulation and coating materials, shockproof, waterproof, moistureproof, prevent leakage and spark, arc, etc.

Main technology parameters:

type	Ss8499
The concept	cream
color	Transparent, white and black
Curing type	Latter off
Density( G/cm3)	1.37±0.05
Dry time table (min )	15~30
Elongation (%)	450
Hardness shore (A)	20~48
Working temperature (c)	-60~200
The fixed time (h,2mm)	24
Quality weightlessness rate (%)	2
Surface resistivity (Q)	8×1014
Volume resistivity (Q/cm)	3×1014
The dielectric constants (106Hz )	2.8
Dielectric loss Angle tangent (1MHz)	4×103
Breakdown strength (KV/mm)	20
thermal conductivity w/m.k	20.25
Main uses	such products than ordinary from silicone pad is more superior oil resistance, is mainly used in the electronic pump seals, etc

Method of use:

1,For best results, sealing components for sealing surface should be clean, dry, without impurities, oil or other besmirch, with no alcohol or acetone clean water

2,According to size, will cut pointed out from the hose, rubber coated adhesive directly, glue mucilage that should have enough on both sides with joint area.

3,After the glue should be completed within short time. Trim.

4,At 12 ~ 24 hours, absorb moisture in the air to trace. If the sub thick and adhesive surfaces, curing time, large conversely, adhesive placement after a short time longer cementation, the better the results. At room temperature curing temperature components placed - 50 ° c ~ after bigger, humidity 150 ° situation 4 ~ 12 hours, baked adhesive effect is better.

5,As a finish after opening, not finished, cover tightly with air hose, avoid moisture contact can save time and use. Again, when using, squeeze has cured after part, can continue to use.

Note:
1 and after use, tighten the cover, preventing air containers.
2,This series of products, non-toxic, but should avoid into the mouth, if carelessly eye contact with eyes or skin, please immediately rinse and medical treatment.
3 in the well ventilated place, please use the product.

Packaging, storage and transportation:
1, 300g/teams.
2 and stored in 25 degrees below the dry and ventilated place, for a period of 6 months, far away from children.
3, this product is not solvent products according to the dangerous goods, and shipping